Uvp Spot-Lite System Manuel d'utilisateur

SPOT-LITE CURING SYSTEMUSERS GUIDEhttp://www.uvp.comUVP, Inc. Ultra-Violet Products Ltd.2066 W. 11th Street Unit 1, Trinity Hall Estate, N

Spot-Lite Users GuideSpecificationsLamp: 400w short wave (L1) or long wave (L2)Light intensity L1 at 254nm 15mw/cm2at 310nm 15mw/cm2at 365nm 15mw/c

Spot-Lite Users GuideOrdering InformationSpot-Lite Base Units (supplied without wands)Spot-Lite L1/2 base unit with L1 lamp and 2 wand socketsSpot

Spot-Lite Users GuideContentsContents 2Preface.. 3Introduction

Spot-Lite Users GuidePrefaceCopyrightThis manual is copyright UVP 1993. All rights reserved. No part of this manual can be reproduce

Spot-Lite Users GuideIntroductionAbout this GuideThis guide provides complete instructions to set up and run UVPs Spot-Lite system.The manual full

Spot-Lite Users GuideComponentsBase UnitThe base unit is available with a choice of two lamps  400w short wave (L1) or long wave (L2).Thanks to a

Spot-Lite Users GuideOperationPositioningPosition the unit close to the area where the curing is to take place and in a position where any lightdi

Spot-Lite Users GuideTimerTimer settings are as follows:99.99S 999.9S9999S 99 min 59599.99 min 999.9 min9999 min 99h 59 min99.99h 999.9h9999hThe

Spot-Lite Users GuideCuringOnce the unit is warmed up the timer has been set curing can commence. The end(s) of thewand(s) should be held or fixed

Spot-Lite Users GuideLamp ReplacementIf a lamp has ceased functioning, it should be replaced as follows:NB. Always ensure that the Spot-Lite has